TERADEK BOLT 500 XT (SDI/HDMI, 2xRx, 150m)
The TERADEK BOLT 500 (SDI/HDMI, 1xRx) includes one transmitter and one receiver. This set enables you to immediately start transmitting up to 1080p60 video from either an SDI or HDMI source. The zero-latency transmitter/receiver pair features 500′ line-of-sight transmission distance when used together. You can send and receive visually lossless 3G video signals from a Bolt 1000 transmitter with zero latency. The transmitter features cross conversion, so you take an SDI signal in and loop out either an SDI or HDMI signal to your on-camera monitor.
The receiver also features both SDI and HDMI outputs, and the system supports digital SD and HD signals. Although the inputs and outputs support a variety of HD signals in both 50 and 60 Hz standards, as well as 480i and 576i, 480p, and 576p are only supported via HDMI. You can transmit up to three other third-generation Bolt receivers as the transmitter can support up to four receivers. The built-in AES 128-bit encryption helps keep your transmitted video safe from prying eyes.
1 x Case TERADEK BOLT 500
1 x TERADEK BOLT 500 XT TX SDI-HDMI Transmitter
2 x TERADEK BOLT 500 XT RX SDI-HDMI Receiver
1 x Cable SDI TERADEK 50cm BIT 040 (11-0040)
1 x Cable HD-SDI BNC to BNC 0,3-1m
2 x Cable 2pin Lemo/M to D-Tap TERADEK 0,5m BIT 112
2 x TERADEK Wireless Antenna 022
-
- Range
150 m
-
- Supported Video
1080p: 60/59.94/50/30/29.97/25/24/23.98
1080PsF: 30/29.97/25/24/23.98
1080i: 60/59.94/50
720p: 60/59.94/50
480i: 59.94
576i: 50
-
- Input/Output
Video Inputs Transmitter
1 x SD/HD/3G-SDI (75 Ohm BNC)
1 x Type A receptacle HDMI
Video Outputs Transmitter
1 x HD/SD/3G-SDI Loop-out (75 Ohm BNC)
Video Outputs Receiver
1 x SD/HD/3G-SDI (75 Ohm BNC)
1 x HDMI Type-A receptacle
-
Panel Antenna Array 5GHz 3x16dB 2x14dB
-
Power Pack incl. Charger and two batteries (for Monitors)
-
TERADEK Sidekick II HD-SDI Kit for 500/1000/3000
You must be logged in to post a review.
Reviews
There are no reviews yet.